mistermango
New Member
- Messages
- 7
- Reaction score
- 0
- Points
- 0
Hi. I need some advice on what the best solution is for my hot water issues.
It takes a long time for our bathroom sinks to deliver hot water (the heater is clear on the other end of my brick rancher). The house is on a slab, so I have no access to install a return line for a recirculating system. The sinks are at the end of the line.
The two sinks are on the same wall, and I'd like to improve both of their performance, so as not to waste gallons of water every time I need hot water. Hot water is not as hard to come by in the showers, but could stand for a bit of improvement.
I'm contemplating a small point of use heater. I am also considering an under-the-sink recirculator, such as a Grundfos or a ReadyTemp. Would either be better than the next for also boosting the hot water delivery at the showers?
Anyone have any suggestions? Thanks.
It takes a long time for our bathroom sinks to deliver hot water (the heater is clear on the other end of my brick rancher). The house is on a slab, so I have no access to install a return line for a recirculating system. The sinks are at the end of the line.
The two sinks are on the same wall, and I'd like to improve both of their performance, so as not to waste gallons of water every time I need hot water. Hot water is not as hard to come by in the showers, but could stand for a bit of improvement.
I'm contemplating a small point of use heater. I am also considering an under-the-sink recirculator, such as a Grundfos or a ReadyTemp. Would either be better than the next for also boosting the hot water delivery at the showers?
Anyone have any suggestions? Thanks.
Last edited: