tnr122
New Member
Hello,
I had my floor cut open to add things in my utility room. The cast iron pipe was not buried very deep and by DUMB LUCK the cutters partially severed the pipe between a transition from 1 1/2" to 3". I am excited that I have 3" but have only 3/8" of the 3" pipe sticking out of the hub. My intention was to use a Fernco no-hub to connect to PVC but want to remove the stub piece and replace it with a few more inches instead of the 3/8". How do you recommend replacing the lead in a horizontal hub?
Thanks
I had my floor cut open to add things in my utility room. The cast iron pipe was not buried very deep and by DUMB LUCK the cutters partially severed the pipe between a transition from 1 1/2" to 3". I am excited that I have 3" but have only 3/8" of the 3" pipe sticking out of the hub. My intention was to use a Fernco no-hub to connect to PVC but want to remove the stub piece and replace it with a few more inches instead of the 3/8". How do you recommend replacing the lead in a horizontal hub?
Thanks