Hey all,
Noobie here, redoing the bathroom, tore out the walls and have a several questions:
1. Can I just cut off or heat up and remove the valves to cap them? Then when I'm done, put new valves on them? Or should I just cut everything out?
2. The 'green' corrosion, is that ok? Should I cut the pipe or heat the pipe off from the angle?
3. If you see the first pic, you should see that the cold water pipe going to the toilet. Its kind of bent. I sure as hell didn't do it but its working fine. While I have the walls up, should I change that out?
I'm asking these questions because I don't want to run into any problems later on after I seal up the walls.
Thanks guys!
Noobie here, redoing the bathroom, tore out the walls and have a several questions:
1. Can I just cut off or heat up and remove the valves to cap them? Then when I'm done, put new valves on them? Or should I just cut everything out?
2. The 'green' corrosion, is that ok? Should I cut the pipe or heat the pipe off from the angle?
3. If you see the first pic, you should see that the cold water pipe going to the toilet. Its kind of bent. I sure as hell didn't do it but its working fine. While I have the walls up, should I change that out?
I'm asking these questions because I don't want to run into any problems later on after I seal up the walls.
Thanks guys!