postles
New Member
So, I've done something silly while dealing with water damage under a toilet. While nailing in bracing to support the new piece of subfloor, I managed to pierce a wye below the toilet where the drain line from the tub ties in. The hole I created is pretty much right at 90 degrees on the side, smack in the middle of the fitting. Am I thinking too wishfully that it might be possible to use something like JB Weld or melt the PVC with a hot putty knife, or should I go ahead and start yanking everything out? Thanks for not laughing too hard at my stupidity. Stupid truss joists.