I bought ~1300 square feet of Mannington Adura Vinyl Tiles. Installation Instructions I cannot find anyone to do just a 100 ft bathroom and closet at this time. I need to get it done before I can tear up the other bathroom and the rest of the house and install the remaining 1200 ft. Does anyone have any tips on installing this floor? From what I read the pressure sensitive glue is applied with a notched trowel and allowed to set up (10 min. or so) and then tiles applied and rolled with 100 lb roller.
Specifically, do you lay a row and then put down a piece of plywood so you can kneel on the tile and work on the next row? And then roll when done?
What do you do where the glue is spread out past the tile of one section? It will be too dry to use for the next section so I guess you scrape it up and spread new?
I cannot find hardly any info on this on the internet. Just not commonly a DIY project I guess.
Thanks!
Specifically, do you lay a row and then put down a piece of plywood so you can kneel on the tile and work on the next row? And then roll when done?
What do you do where the glue is spread out past the tile of one section? It will be too dry to use for the next section so I guess you scrape it up and spread new?
I cannot find hardly any info on this on the internet. Just not commonly a DIY project I guess.
Thanks!