Washing machine drain-p trap info

Terry · Feb 2, 2010

In some plumbing codes, they will require a vent for the washer, and a vent for the sink.

It depends on where you are, and whether you want the inspector to pass off on your plumbing.
For about 3 bucks, you can move on with your project.
The photo was done to pass UPC codes.

Lightmark · Feb 2, 2010

I'm right in the middle of putting this in when I saw your post. My grateful thanks to you and your super photo. We are in upc code area.

Sponsor · 2022-01-29T12:20:58-0800

Lightmark · Feb 2, 2010

May I also ask why the vent for the washer, I assume its the one to the right of the sink or tub trap arm, is not angled towards the standpipe? Thanks so much for any feedback!

Lightmark · Feb 2, 2010

I have from right to left, standpipe, the p trap and an inch of pipe, a horizontal tee under a san tee (vented) draining a bar sink on other side of wall. I can only put the second vent sweep on the horizontal drain running left of horizontal tee which is under vertical tee, stacked to left of p trap.

Does it make sense?

Terry · Jun 2, 2010

Adding a standard rough for a washer with dryer box.
The vent on the left from the downstairs is for the first floor kitchen.
The washer box has hammer arrestors.

Washing machine drain-p trap info

Users who are viewing this thread

Terry

The Plumbing Wizard

Lightmark

New Member

Sponsor

Paid Advertisement

Lightmark

New Member

Lightmark

New Member

Terry

The Plumbing Wizard

Similar threads