Hello,
Basic question, but I dont know the correct answer.
I am putting in a transfer switch. I am using 3/4" sch40 conduit from the exterior power inlet to the transfer switch....and pulling in 4 #10 stranded.
My question is how to attach (what fittings, etc) the sch 40 to the exterior power inlet.
The sch40 will go down between the garage doors and the power inlet is on the exterior siding between the garage doors. The wall is approx 6" ( drywall, stud, plywood sheething and siding).
I was told to use a liquid tight fitting up against the box...??
What else?
Thanks,
Homer
Basic question, but I dont know the correct answer.
I am putting in a transfer switch. I am using 3/4" sch40 conduit from the exterior power inlet to the transfer switch....and pulling in 4 #10 stranded.
My question is how to attach (what fittings, etc) the sch 40 to the exterior power inlet.
The sch40 will go down between the garage doors and the power inlet is on the exterior siding between the garage doors. The wall is approx 6" ( drywall, stud, plywood sheething and siding).
I was told to use a liquid tight fitting up against the box...??
What else?
Thanks,
Homer