Jaaron
New Member
I put in a temptrol symmons valve and connected it to pex pipes and tested it before tiling the shower and it worked and now I notice that there is no water passing . I've tried removing the spindle from the valve and there is still no water just a slight leak. I've tried both the hot and cold water and the response is still the same. The same plumbing is providing good flow to the sink .
Before putting a hole in the finished wall to check out the plumbing more carefully does anyone have any other suggestions as to what I can do to make it work.
If the pressure is not equal on the hot and cold sides will the valve not work?
thanks
Jay
http://www.symmons.com/Customer-Service.aspx
Before putting a hole in the finished wall to check out the plumbing more carefully does anyone have any other suggestions as to what I can do to make it work.
If the pressure is not equal on the hot and cold sides will the valve not work?
thanks
Jay
http://www.symmons.com/Customer-Service.aspx
Last edited by a moderator: