BimmerRacer
Member
Do I need to put anything between two halves or do I just crank it down to seal it?
Brass Unions
- Thread starter BimmerRacer
- Start date
Users who are viewing this thread
Do I need to put anything between two halves or do I just crank it down to seal it?
SewerRatz
Illinois Licensed Plumber
Just tighten them down the ground face of the union will make the seal.
Sponsor
Paid Advertisement
BimmerRacer
Member
Thanks Ron!
Jadnashua
Retired Defense Industry Engineer xxx
A couple of things...make sure the pipes are aligned when you tighten things up. And, especially if you overtighten, you may find you create a ridge on the sealing surfaces, so if you need to tak it apart, it becomes more difficult to seal unless you get it aligned perfectly.
hj
Master Plumber
- Messages
- 33,608
- Reaction score
- 1,047
- Points
- 113
- Location
- Cave Creek, Arizona
- Website
- www.terrylove.com
unions
I usually use pipe joint compound on the faces and the threads of the union nut to give some lubrication to the process.
I usually use pipe joint compound on the faces and the threads of the union nut to give some lubrication to the process.
Shacko
Master Plumber-Gas Fitter
Unions
Do to the fact that most fittings are made off planet, I also use a little pipe compound on the face, your choice.
Do to the fact that most fittings are made off planet, I also use a little pipe compound on the face, your choice.
BimmerRacer
Member
Thanks for the tips gents
Similar threads
