chickenbrown
New Member
I am looking to add a small cast iron wall radiator in my 10 foot by 5 foot bathroom because my wife says its cold after coming out of the shower in winter. I was thinking to just add it into the closest zone off my hot water boiler but since the t-stat is in the bedroom i think it would be too hot since the bedroom has a few windows and the bath does not. The bedroom is very close but when the doors are closed the T-stat will not regulate the bath properly.
Can i just tap into the end of this zone with a vanturi or scooped tee just to get some flow through this new added rad or can i go even a step further and put a t-stat on the scooped tee to allow heat when the bath needs? Does this fitting exist? a tee that regulates flow off and existing zone when the bath needs heat.
thanks
Can i just tap into the end of this zone with a vanturi or scooped tee just to get some flow through this new added rad or can i go even a step further and put a t-stat on the scooped tee to allow heat when the bath needs? Does this fitting exist? a tee that regulates flow off and existing zone when the bath needs heat.
thanks