DigitalJim
New Member
I am moving my washer 12' and installing a new 2" drain. Due to the placement of the washer box, a standard off-the-shelf p-trap won't fit without cutting out a large portion of the stud (vertical of p-trap falls in line with stud).
Is there any reason why a built up p-trap using 90 deg elbows would not be allowed and/or recommended? Also, is there a width limitation on a trap? I would have to extend the width on the bottom of the trap about 3" to pass through the stud.
Thanks in advance for any comments.
Is there any reason why a built up p-trap using 90 deg elbows would not be allowed and/or recommended? Also, is there a width limitation on a trap? I would have to extend the width on the bottom of the trap about 3" to pass through the stud.
Thanks in advance for any comments.