Steveleewonder
New Member
- Messages
- 25
- Reaction score
- 0
- Points
- 0
Hello all...
I have a question on water amount depending on split point.
2inch city water line comes into building, and it splits to another 2inch line(A) by "T" connection, and runs continuously to 2inch water supply line(B).
line "A" has 20 water outlet such as sink, toilets, kichens etc..., and line "B" has 40 water outlets..., "B" water line(group) use(spend) double amount of water than line "A". But sometimes, "B" experience lack of water( pressure drop, amount of water smaller) due to water usage increase in "B" group. my question is if line "B" and "A" swap each other, then it makes any difference on water amount(pressure)? or same? my goal is to improve water shorage situation only in "B" group.
Thanks,
I have a question on water amount depending on split point.
2inch city water line comes into building, and it splits to another 2inch line(A) by "T" connection, and runs continuously to 2inch water supply line(B).
line "A" has 20 water outlet such as sink, toilets, kichens etc..., and line "B" has 40 water outlets..., "B" water line(group) use(spend) double amount of water than line "A". But sometimes, "B" experience lack of water( pressure drop, amount of water smaller) due to water usage increase in "B" group. my question is if line "B" and "A" swap each other, then it makes any difference on water amount(pressure)? or same? my goal is to improve water shorage situation only in "B" group.
Thanks,