Hello all-
I need to replace the o-rings that make the seal between the Bypass Valve and the softener on my GE Smart Water system. The problem I am having is that I can figure out how to remove the clips that secure the bypass valve. Is there a special tool needed or can they be removed with a screw driver or pliers?
I bought new clips in case I break one but I can't get them to budge
Attached is a pic of the clip. Any advice would be appreciated.
Thanks!!
I need to replace the o-rings that make the seal between the Bypass Valve and the softener on my GE Smart Water system. The problem I am having is that I can figure out how to remove the clips that secure the bypass valve. Is there a special tool needed or can they be removed with a screw driver or pliers?
I bought new clips in case I break one but I can't get them to budge
Attached is a pic of the clip. Any advice would be appreciated.
Thanks!!