(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 4 of 4

Thread: Hot Water Tank Vent Code Question

  1. #1
    DIY Senior Member molo's Avatar
    Join Date
    Sep 2006
    Location
    cold new york
    Posts
    840

    Default Hot Water Tank Vent Code Question

    Details: 2 story building
    Hot Water Tank located in basement
    Vent exits an old basement window and goes up the side of house and goes out around eve.
    Question 1:
    Are the bends at the eve acceptable or does the pipe need to be held out away from the building for the entire length up the house so that there is no bend at the eve?
    Question 2: Where can I find code information for venting hot water tanks?

    Thanks for any replies
    "Any American who is prepared to run for President should automatically, by definition, be disqualified from ever doing so."
    Gore Vidal.

  2. #2
    Plumber jimbo's Avatar
    Join Date
    Aug 2004
    Location
    San Diego
    Posts
    9,001

    Default

    You are probably OK. The primary instruction for venting is in the manual for the specific unit, because first and foremost all plumbing related fixtures must be installed in accordance with the instructions from the manufacturer.

    On the other hand, the manufacturer, and most if not all code authorities, invoke the National Fuel Gas Code. So that is the reference you should consult. That book is inexpensive and readily available.

  3. #3
    Plunger/TurdPuncher kingsotall's Avatar
    Join Date
    Aug 2008
    Location
    Flagstaff, AZ Sitting on an upside down 5 gallon bucket next to the GO 68HD
    Posts
    1,260

    Default

    6" clearance or B-vent, cumbustible surface penetration, B-vent.
    I just post cuz I like to see my avatar.

  4. #4
    Moderator & Master Plumber hj's Avatar
    Join Date
    Aug 2004
    Location
    Cave Creek, Arizona
    Posts
    25,653

    Default vent

    Your biggest problem is that an uninsulated vent that long probably has ZERO draft, so the fumes are being vented into the basement. At the very least it should be class "B" vent which would have SOME chance of staying warm enough to keep the draft flowing.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •