Duke76
New Member
- Messages
- 34
- Reaction score
- 0
- Points
- 0
When I bought my house I had a partially installed irrigation system drawing water from a lake. The last step of the installation is to connect the pump (which is located on a floating dock) to the onshore PVC piping for the system.
I am connecting PE pipe from the pump to the PVC using barbed fittings. The Silverline website says I can dip the end of the pipe in hot water to soften it. Does this work ? Would a hair dryer work ?
Can someone give me any other tip on how to force the PE over the barb ?
Thank you.
I am connecting PE pipe from the pump to the PVC using barbed fittings. The Silverline website says I can dip the end of the pipe in hot water to soften it. Does this work ? Would a hair dryer work ?
Can someone give me any other tip on how to force the PE over the barb ?
Thank you.