hhcibtpaun
Member
Hey Everyone,
I had a general question about the gasket used between the tub drain and the tub (tub shoe gasket I think)?
I was dryfitting everything before I concrete everything in and in a steady state, my tub shoe is offset from the bottom of the tub a little more than I planned for. I have two of the rubber gaskets....can I stack them, or can I get extra thick ones? The one I have is about 1/4"...I think I saw 3/8" ones...but 1/2" may work better.
I am assuming stacking may be ok, since the interface to the tub will still be fine. I will use plumbers putty on the topside of the drain.
TIA...Mike
I had a general question about the gasket used between the tub drain and the tub (tub shoe gasket I think)?
I was dryfitting everything before I concrete everything in and in a steady state, my tub shoe is offset from the bottom of the tub a little more than I planned for. I have two of the rubber gaskets....can I stack them, or can I get extra thick ones? The one I have is about 1/4"...I think I saw 3/8" ones...but 1/2" may work better.
I am assuming stacking may be ok, since the interface to the tub will still be fine. I will use plumbers putty on the topside of the drain.
TIA...Mike