Good Day All:
We just installed a brand new Gerber Aqua Saver Toilet, #28-794 14" RI. Followed install instructions to the letter. Turned the water on, filled the tank and - no flush power at all.
It appears that gravity just isn't doing the job. Water is just not getting into the bowl fast enough. The bowl fills all right, but very slowly; so much so that it seems there is not enough pressure to give us an actual flush.
Everything is installed properly. Flap wide open, chain correct length. No blockages, the rim holes are tiny, but functioning and the vent on the roof is clear. Does this thing have to be primed or something?
Any suggestions offered would be greatly appreciated. Thank you so very much for your time.
JD
We just installed a brand new Gerber Aqua Saver Toilet, #28-794 14" RI. Followed install instructions to the letter. Turned the water on, filled the tank and - no flush power at all.
It appears that gravity just isn't doing the job. Water is just not getting into the bowl fast enough. The bowl fills all right, but very slowly; so much so that it seems there is not enough pressure to give us an actual flush.
Everything is installed properly. Flap wide open, chain correct length. No blockages, the rim holes are tiny, but functioning and the vent on the roof is clear. Does this thing have to be primed or something?
Any suggestions offered would be greatly appreciated. Thank you so very much for your time.
JD