(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 4 of 4

Thread: Wiring Tytewadd Power Filter into Panel

  1. #1

    Default Wiring Tytewadd Power Filter into Panel

    Hello all,

    I have the Tytewadd Power Filter C-1 ready to wire into the panel before the lightning really starts up here in the hills this spring. I am wondering if anyone is familiar with installing these? The instructions say to wire the two red leads to a double pole breaker and the white to the neutral bar. We don't have a two pole breaker (all appliances are natural gas) and we have two neutral bars so... what can I wire this to so a lightning strike doesn't fry our wires.

  2. #2
    Licensed Electrical Contractor Speedy Petey's Avatar
    Join Date
    Jun 2007
    NY State, USA


    You need to add a new 2P breaker for the protector. In the main panel it does not matter which neutral bar. They are the same.
    Answers based on the 2008 & 2011 NEC. If you're on the '14 already I feel sorry for you.

  3. #3


    Thank you so much, that makes things easy!

  4. #4
    Like an engineer alternety's Avatar
    Join Date
    Apr 2006


    It would be best to put the new breakers as close as possible to the point the wires from the utility connect to the panel buses. Keep wires as short as possible. Lightening is a very fast rise time pulse and the inductance (think resistance for AC voltage) will lower the effectiveness of the filter a bit


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts