Wfon55
New Member
- Messages
- 6
- Reaction score
- 0
- Points
- 0
I've done some searching on the forum but I've only seen mentions of the TOTO CST703.10 (10" rough), mainly that it splashes when flushed. It seems like this model is the best fit for my installation, which sadly has a 3" forced hot water baseboard to contend with along with an 11.5" rough from the wall (not including the baseboard).
So I'm wondering if anyone out there can comment on their satisfaction level with the Toto CST703.10 or point me to an review of it. I'd also appreciate any suggestions of other models or manufacturers I should consider given the installation constraints. (Photo of existing American Standard toilet & drawing of the Toto provided below).
I've read that I should consider installing a waxless seal given the baseboard heater, but my old American Standard has had no problems other than using way too much water.
Thanks everyone!
So I'm wondering if anyone out there can comment on their satisfaction level with the Toto CST703.10 or point me to an review of it. I'd also appreciate any suggestions of other models or manufacturers I should consider given the installation constraints. (Photo of existing American Standard toilet & drawing of the Toto provided below).
I've read that I should consider installing a waxless seal given the baseboard heater, but my old American Standard has had no problems other than using way too much water.
Thanks everyone!
Attachments
Last edited by a moderator: