kendog2
New Member
- Messages
- 9
- Reaction score
- 0
- Points
- 0
We are installing a doorless walk-in shower. It will have inside measurements of 32"x72". We want to have a shower head at one end and a hand-held with a bench at the other end. I have been reading the posts about how much the valves and trim kits cost. It's pretty scary.
We need to do this as inexpensively as possible. We are considering the Moentrol 3330 3 function valve. Would it be less expensive to install 2 separate valves? Can anyone recommend the best system for this purpose and suggest where to buy it? Would two separate valves be more trouble-free than one valve? We plan to run the pipes around the corner to the back wall of the shower so we can turn on the shower without getting hit by the cold water. Must the pipes be soldered or can we use Copper Bond made by Super Glue? Thanks.
We need to do this as inexpensively as possible. We are considering the Moentrol 3330 3 function valve. Would it be less expensive to install 2 separate valves? Can anyone recommend the best system for this purpose and suggest where to buy it? Would two separate valves be more trouble-free than one valve? We plan to run the pipes around the corner to the back wall of the shower so we can turn on the shower without getting hit by the cold water. Must the pipes be soldered or can we use Copper Bond made by Super Glue? Thanks.