Just bought my first drake today and put it in. One problem I had with the install though... the instructions seem very clear about the tank making three points of contact with the bowl. I wasn't able to get mine to make contact on any of these though... the rubber gasket seems to stick up too high, and I was concerned about overtightening it and breaking something...
Right now it's not making contact on any of those 3 points, just sitting on top of the gasket. It's got maybe 1/8" space from the bottom of the tank to the 3 raised points on the bowl. The tank isn't leaking, but I'm wondering if its ok to leave it like that, or if I should just go ahead and tighten it down further.
I have a ST743S (drake) tank with a C744EG (eco-drake?) bowl. These should be compatible, right?
Thanks! And thanks for all the great info on this site. I'm hoping that I too will be able to throw away my plunger...
Right now it's not making contact on any of those 3 points, just sitting on top of the gasket. It's got maybe 1/8" space from the bottom of the tank to the 3 raised points on the bowl. The tank isn't leaking, but I'm wondering if its ok to leave it like that, or if I should just go ahead and tighten it down further.
I have a ST743S (drake) tank with a C744EG (eco-drake?) bowl. These should be compatible, right?
Thanks! And thanks for all the great info on this site. I'm hoping that I too will be able to throw away my plunger...