jobsite fan question

Users who are viewing this thread

wrdtlpf

Carpentry/Handyman Service
Messages
19
Reaction score
0
Points
0
Location
Connecticut
Hey guys- Not sure if this is the right place but not sure where else to look. I have a job site fan with a three position rotary switch: low, med and high. When I have it on any speed but most noticeably on low the fan's RPM will all of a sudden climb but not as high as if it were set to 'med'. Is the switch bad somehow and allowing some current to pass? Motor dying? Any input would be great, Thanks.
 
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks