Hi All,
I am brand new here, looks like a good, useful place.
Wilkins 600 pressure reducer, specifically 3/4" version, at least 10 years old. It regulates just fine while there is even a small flow. After flow stops the delivered pressure sneaks up (10 seconds) to the full supply pressure. I actually have two of these and have already bought one repair kit.
So ...
What is the most likely point of seepage?
Is it likely to be a resilient thing to replace or a brass surface to polish?
Can I get to it by only removing the "cap" opposite the adjustment bolt?
Any input welcome. Thanks in advance
Bob2
I am brand new here, looks like a good, useful place.
Wilkins 600 pressure reducer, specifically 3/4" version, at least 10 years old. It regulates just fine while there is even a small flow. After flow stops the delivered pressure sneaks up (10 seconds) to the full supply pressure. I actually have two of these and have already bought one repair kit.
So ...
What is the most likely point of seepage?
Is it likely to be a resilient thing to replace or a brass surface to polish?
Can I get to it by only removing the "cap" opposite the adjustment bolt?
Any input welcome. Thanks in advance
Bob2