Taco Ciruclation pump is whining

Users who are viewing this thread

DIYMike

New Member
Messages
31
Reaction score
0
Points
0
Model: 006 BC4 PNP
3 years old, already installed. Was whining. I thought it was the replacable cartridge/impeller and replaced it. It wasn't. Still whining. Seems to be moving water, but just whines.

1) Is this common? Is it due to having the unit on a timer?
2) I assume it's in the motor housing, and will drain/disassemble to investigate. Can I run it dry momentarily just to investigate?
3) If I need to replace the whole assembly - and I'm assuming that I can reuse the sweated "base" (the rest of the housing just bolts on with a gasket) are there less expensive models that I can use instead, that will still fit the base?

Thanks!
 
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks