I am remodelling my basement and fixing metal stud framing around the exterior wall area. I am using screws.
This is all going fine except drilling into the concrete slab to fit the trough using anchors and tapcons is proving difficult.
I have tried using concrete drill bits and even ones for granite but on some areas a single hole will dull an entire bit.
Is there an easier way to do this that will save me cash on going through drill bits?
I do not want to use nails though (or is this why people use nails?).
This is all going fine except drilling into the concrete slab to fit the trough using anchors and tapcons is proving difficult.
I have tried using concrete drill bits and even ones for granite but on some areas a single hole will dull an entire bit.
Is there an easier way to do this that will save me cash on going through drill bits?
I do not want to use nails though (or is this why people use nails?).