peterpilot
New Member
- Messages
- 2
- Reaction score
- 0
- Points
- 0
My neighbour lives in his fifth wheel trailer. He developed a sewage problem that is puzzling us both. He has no computer.
All sewage from his trailer holding tank is piped to an outdoor sump some distance away, and below the level of the trailer.
This sump is like a large plastic bucket about 2ft diameter by 3ft high. It contains a pump with float switch, and a PVC check valve above the pump. This 2 inch PVC then continues to his sister's septic tank some 50ft away. Apart from thread to the pump, everything is glued.
Everything has worked well in the three years since installation. Until, that is, a week ago. We had an unusual cold spell for a few days to minus 10 C (about 14 F). The effluent in the sump, as well as in the PVC unburied section outflow line froze, and burst the line between the trailer and the sump. All this was discovered when the temperature rose, and the contents of the septic tank above the trailer's output line drained out. Not knowing at this time exactly what was happening, he unplugged the power to the sump pump. When things slowed to a drip, my neighbour taped the cracked line with duct tape, which made a good temporary seal.
He then transferred some effluent from his holding tank to the outside sump, which made the pump turn on (normal hum was heard), but pumpout was not happening.
He unbolted the cover and lifted the pump and check valve assembly out of the sump and placed it outside. Nothing was obviously wrong from the outside. Power was reconnected. Manual lifting of the float switch turns the pump motor on. Inspection through bottom hole confirms that impeller is spinning. Assembly was returned to sump, and repowered. Since float was up, pump turned on, but effluent level didn't change after a minute, so power was removed.
What could be wrong? Could the freezing have damaged the check valve to cause it to be stuck in the closed position? Could a pin be sheared between motor shaft and impeller so that the impeller slips?
Any opinions or ideas? Thanks!
All sewage from his trailer holding tank is piped to an outdoor sump some distance away, and below the level of the trailer.
This sump is like a large plastic bucket about 2ft diameter by 3ft high. It contains a pump with float switch, and a PVC check valve above the pump. This 2 inch PVC then continues to his sister's septic tank some 50ft away. Apart from thread to the pump, everything is glued.
Everything has worked well in the three years since installation. Until, that is, a week ago. We had an unusual cold spell for a few days to minus 10 C (about 14 F). The effluent in the sump, as well as in the PVC unburied section outflow line froze, and burst the line between the trailer and the sump. All this was discovered when the temperature rose, and the contents of the septic tank above the trailer's output line drained out. Not knowing at this time exactly what was happening, he unplugged the power to the sump pump. When things slowed to a drip, my neighbour taped the cracked line with duct tape, which made a good temporary seal.
He then transferred some effluent from his holding tank to the outside sump, which made the pump turn on (normal hum was heard), but pumpout was not happening.
He unbolted the cover and lifted the pump and check valve assembly out of the sump and placed it outside. Nothing was obviously wrong from the outside. Power was reconnected. Manual lifting of the float switch turns the pump motor on. Inspection through bottom hole confirms that impeller is spinning. Assembly was returned to sump, and repowered. Since float was up, pump turned on, but effluent level didn't change after a minute, so power was removed.
What could be wrong? Could the freezing have damaged the check valve to cause it to be stuck in the closed position? Could a pin be sheared between motor shaft and impeller so that the impeller slips?
Any opinions or ideas? Thanks!