Under the handle is a hot limit stop it probably needs to be adjusted properly.
Do you know what the model # is?
|
|
|
Few months ago a handyman remodel the upatairs bathroom, I tried to shower but didnt get hot water...!!!!any suggestions will be appreciated!!
Under the handle is a hot limit stop it probably needs to be adjusted properly.
Do you know what the model # is?
Thanks for replying!! and no i dont know the model#...! i took it apart ..... and it does have some plastic stopppers but even when i turn the water on with out them it still comes out cold ... i only get a little warm after i pass the 180 degree turn but only get a tritkle of water!!Any suggestions !!!
Sounds like one of two things: the pressure balance spool valve is stuck, or there is some debris caught in the hot inlet. If there's an in-line stop valve, it could be closed. How old is the house? Could there be some galvanized pipes in there that are all clogged up with rust?
Jim DeBruycker
Important note - I'm not a pro
Retired Defense Industry Engineer
im not sure around 50s and ill check for the galvanize pipe!!!\
Or the handyman melted down the cartridge...
Answer the questions in the pull down menus under
DON'T KNOW YOUR MODEL OR REPLACEMENT PART NUMBER?
At this link and find your valve.
http://www.moen.com/buymoen/buyparts/index.cfm
Sounds like it might be a posi-temp.
Bookmarks