(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 8 of 8

Thread: solenoid breaker trip

  1. #1
    DIY Member brother's Avatar
    Join Date
    Dec 2007
    Location
    Washington
    Posts
    53

    Wink solenoid breaker trip

    have a solenoid that keeps triping the breaker. the solenoid been change 2 times and the breaker has been changed. there is nothing else on the line, and line is good. Would the valve on the solenoid get jammed on these even on the new ones that been put in??
    Last edited by brother; 11-30-2008 at 05:07 PM. Reason: tried to get rid of advertisement!!

  2. #2
    Master Plumber Redwood's Avatar
    Join Date
    Dec 2007
    Location
    Connecticut
    Posts
    7,463

    Default

    Lets have some of the details on the solenoid valve...
    At least the manufacturer and model please...

  3. #3

    Default

    Where is this solenoid? What does it control? Your question is to broad based to even begin to form a opinion or answer. Please give more detailed information.
    Cal's Plumbing Online
    www.calsplumbingonline.com

  4. #4
    Moderator & Master Plumber hj's Avatar
    Join Date
    Aug 2004
    Location
    Cave Creek, Arizona
    Posts
    25,673

    Default solenoid

    Solenoids do not usually cause problems, but whatever they are controlling CAN. What is the solenoid doing?

  5. #5
    DIY Senior Member gardner's Avatar
    Join Date
    Apr 2007
    Location
    Ontario
    Posts
    217

    Default dumb questions

    Is the breaker a GFI? Is it tripping because of a ground fault or overcurrent? Have you double checked it is wired properly? Is the breaker?

  6. #6
    DIY Member brother's Avatar
    Join Date
    Dec 2007
    Location
    Washington
    Posts
    53

    Wink

    This breaker is not gfi, this is a 25watt 120 volt solenoid on a 1 amp breaker. the amp readings show only 0.2 amps, which is what it should be. I suspected maybe some debri getting in the water line, but they(plumbers) claim the line is pretty clean and the people use the water hose alot.

    Any suggestions would be appreciated.

  7. #7
    DIY Senior Member gardner's Avatar
    Join Date
    Apr 2007
    Location
    Ontario
    Posts
    217

    Default

    1 amp breaker
    The "breaker" is not in your electrical panel then. It must be part of some equipment. Do you mind explaining what the application is?

    It would surpise me if anything in the water would affect the electrical performance of the solenoid. It should draw the same current when completely jammed as when operating normally.

    Have you inspected all the wiring to ensure you do not have a short somewhere due to worn wire insulation or something of that sort?

  8. #8
    Moderator & Master Plumber hj's Avatar
    Join Date
    Aug 2004
    Location
    Cave Creek, Arizona
    Posts
    25,673

    Default solenoid

    All a solenoid does is allow the valve to open. If it does not happen for any reason, it does not affect the solenoid in the slightest. A solenoid is an electromagnet, and it either functions or it doesn't, but if it trip a breaker it should do it every time. It cannot heal itself sporadically.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •