7072
New Member
My water is low ph so I have had an acid neutralizer for some time. It has always worker good with no problems. It is just a simple upflow with no backwash. I installed a tankless water heater. When re plumbing everything I discovered the neutralizer was backwards (water going in the outlet and out the inlet) So when I re did it I Hooked it up properly. About two days later I noticed a small leak around the O ring where the head screws in the tank. I tightened it a little and it seemed ok. The next day I went down to find a flooded basement. It blew the O ring out and was pouring water. I tried everything, but finally determined the threads in the tank were striped, even though they looked ok. Ordered a new tank and installed a new O ring. Turned on the water and it blew out the O ring within 5 minuets. Now the head will not tighten up, seemes like it is striped. I guess I need a new head. Anyone know where I can get just the head. Any suggestions ? This is giving me a fit !!!