I went from a 34" X 48" pan to a smaller 32" X 48" pan. By doing this I just realized that my shower handles are way off now. I also was planning on switching from a two handle to a single handle moen valve.

(The left handle is actually where the center of the shower/valve should be)

1) How would I move the supply lines and valve to work with the new pan.

2) Can I just use two 45 degree fittings to move the left supply line to the left about 4-6" and then just leave the right supply line alone.

3) Does it matter how high I start the 45's.

Any other suggestions.

Thanks in advance,

dan
Name:  IMG_2164B.jpg
Views: 187
Size:  31.0 KB