01sesedan
Member
Here's my problem.
After installing the tiles on the wall, the center of the flange is 11" from the finished wall. I have the pipe sticking out above the floor, maybe 1.5', the elbow is 4" on the flange side and 3" on the drain.
Guess I'm screwed and cannot use 12" rough toilet. Do you think and offset would work? Should I look for 10" rough in? Not sure if there are any tricks to fit in a 12". All of the pipes are in the slab and would be hard to tear everything up again.
Thanks for you help..
Joe
Toto Drake works with 10-7/8" rough-in
After installing the tiles on the wall, the center of the flange is 11" from the finished wall. I have the pipe sticking out above the floor, maybe 1.5', the elbow is 4" on the flange side and 3" on the drain.
Guess I'm screwed and cannot use 12" rough toilet. Do you think and offset would work? Should I look for 10" rough in? Not sure if there are any tricks to fit in a 12". All of the pipes are in the slab and would be hard to tear everything up again.
Thanks for you help..
Joe
Toto Drake works with 10-7/8" rough-in
Last edited by a moderator: