RealJeep
New Member
- Messages
- 9
- Reaction score
- 0
- Points
- 0
I've ran a search but could not find the answer and Google is not much help either. Here's the question:
I have an 80 gallon galvanized steel pressure tank for a well and it has sprung two tiny pin hole leaks in the side about half way up. So far I have not been able to find anything to stick well enough to the galvanized to patch it and I'm not sure solder will either. Working pressure on the tank is no more than 80psi and it's used to collect hot water from solar panels on the roof. I hate the thought of replacing the tank because steel prices have shot through the roof!
I'm open to any and all suggestions...
Otto
I have an 80 gallon galvanized steel pressure tank for a well and it has sprung two tiny pin hole leaks in the side about half way up. So far I have not been able to find anything to stick well enough to the galvanized to patch it and I'm not sure solder will either. Working pressure on the tank is no more than 80psi and it's used to collect hot water from solar panels on the roof. I hate the thought of replacing the tank because steel prices have shot through the roof!
I'm open to any and all suggestions...
Otto