(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 2 of 2

Thread: Codes for PEX

  1. #1
    DIY Member cybervex's Avatar
    Join Date
    Feb 2008
    Location
    Southfield, MI
    Posts
    37

    Default Codes for PEX

    Is there a code that specifies the distance that a pex crimp ring has to be from the shoulder of the fitting I am crimping to. The instructions say between 1/8 and 1/4 from the shoulder.

    Called for a plumbing inspection yesterday morning. The inspector said he would be there at noon. I wish I could have stayed for the inspection but I had to have my mother-in-law wait for him as he did not show until 2:15. He looked (did not check or measure) at the pex crimp fittings and said they were too far from the shoulder of the fitting. He also stated that the crimps were too tight and the pex was bulging and I should have been using a go/no go gauge (again he did not check, just looked).

    When I got home from work yesterday I checked the distance on every crimp in the house to confirm I was between 1/8 and 1/4 inch. I also checked, again, the crimp rings with the gauge to find that once again they all pass according to the gauge.

    Is this just some ploy to get money out of me? Am I really supposed to rework all these crimps to possibly have this ass fail them again as I have to pay for the 3rd inspection?

    Not sure what I am supposed to do here
    ________________________________

    Jay

  2. #2
    Moderator & Master Plumber hj's Avatar
    Join Date
    Aug 2004
    Location
    Cave Creek, Arizona
    Posts
    25,655

    Default Pex

    IF you are absolutely certain that the rings are on according to the MANUFACTURER's specifications and the pass the "GO" and "NO GO" gauge test, then call him back or talk to his supervisor.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •