busterheyman
New Member
I have a 2" sand point down about 35". Water level is at 26" I am using a Sta-rite 1 1/2 HP Horizontal multi-stage jet/centrifugal pump (Model HMSF). This is a single pipe system with 30' of 1 1/4" pipe into the 2" Casing.
I installed the system about 4 years ago and I was getting a flow of about 12 gpm. Water level was at 26'. This year when I started up the system I am only getting about 5-6 gpm.
So far this is what I have tried:
1. I have pulled up the interior pipe and replaced the entire jet assembly/leathers. (Still only 5-6 gpm)
2. I rebuilt the interior of the pump. Impellers/wear rings/gaskets were all replaced. (Still only 5-6 gpm)
I am not sure as to what to do next?
My sprinkler systems was setup using a 12 gpm flow and now it doing a very poor job.
Help!
I installed the system about 4 years ago and I was getting a flow of about 12 gpm. Water level was at 26'. This year when I started up the system I am only getting about 5-6 gpm.
So far this is what I have tried:
1. I have pulled up the interior pipe and replaced the entire jet assembly/leathers. (Still only 5-6 gpm)
2. I rebuilt the interior of the pump. Impellers/wear rings/gaskets were all replaced. (Still only 5-6 gpm)
I am not sure as to what to do next?
My sprinkler systems was setup using a 12 gpm flow and now it doing a very poor job.
Help!