Good morning all........I removed old bathroom vanity, and purchased a new, freestanding vanity.......Problem is: rough plumbing (1 1/2" water pipe) that comes out of the wall is too low to allow for a 'trap'? I cut out the back of the vanity to allow the pipe to fit into the vanity, but it (the pipe) only has 2 inches of clearance below it, to the bottom of the vanity.......Not enough room to allow for a typical 'trap'.......Any ideas on how to get around this, without raising the rough plumbing? Any trap adapters, or something? I'm a complete novice.......
Thanks for any info...
-Bill
Thanks for any info...
-Bill