I am confused about the shower/tub roughin in my basement.
Here is a picture: http://m.UploadEdit.com/e21/599845218.jpg
I need to run a spout for the water below the mixing valve to about 26" above the floor, but the vent appears to be in the way. The vent rises to about 40" until it 90s to join with the main stack.
Is this a common problem?
Should I just make the 90 turn in the vent closer to the floor?
Thanks for any advice.
Here is a picture: http://m.UploadEdit.com/e21/599845218.jpg
I need to run a spout for the water below the mixing valve to about 26" above the floor, but the vent appears to be in the way. The vent rises to about 40" until it 90s to join with the main stack.
Is this a common problem?
Should I just make the 90 turn in the vent closer to the floor?
Thanks for any advice.