on02151blueline
New Member
- Messages
- 4
- Reaction score
- 0
- Points
- 0
Here is some info about the pump & motor:
A.O. Smith Model C48A94A06, SER 8G97, HP 3/4. Also on the A.O. Smith plate is: Goulds NO. J05853L. The cast iron motor adapter has part#1K310 casted into it.
I have a Goulds Jet+Plus pump that the cast iron motor adapter cracked. (I think my irrigation guy didn't drain it properly before winte)
I found the Goulds ITT manual by searching for that part number and want to order one and install it. My problem is that I can't figure out how to get the motor adapter off of the motor shaft. I have found, on this forum thank you, how to remove the impeller, but now I need to remove the spring looking thing that appears to be holding the motor adapter on to the shaft.
My other question is, now that I have the thing apart, are there any other parts I should replace? This motor/pump is pretty old, installed by the previous owner so I have no idea exactly how old it is. It is only used in the spring/summer.
And my last question is, when I am looking at the Goulds ITT manual I assume it is safe to say my model is a J+,right? Under the J+ series heading on the parts listing there are several columuns, J5 J5H J7 J10, J15. How do know which columun to get my part numbers from? I would like to replace the impeller, but there are four different part numbers listed under those five columns.
Thanks in advance for any help anyone could provide me.
A.O. Smith Model C48A94A06, SER 8G97, HP 3/4. Also on the A.O. Smith plate is: Goulds NO. J05853L. The cast iron motor adapter has part#1K310 casted into it.
I have a Goulds Jet+Plus pump that the cast iron motor adapter cracked. (I think my irrigation guy didn't drain it properly before winte)
I found the Goulds ITT manual by searching for that part number and want to order one and install it. My problem is that I can't figure out how to get the motor adapter off of the motor shaft. I have found, on this forum thank you, how to remove the impeller, but now I need to remove the spring looking thing that appears to be holding the motor adapter on to the shaft.
My other question is, now that I have the thing apart, are there any other parts I should replace? This motor/pump is pretty old, installed by the previous owner so I have no idea exactly how old it is. It is only used in the spring/summer.
And my last question is, when I am looking at the Goulds ITT manual I assume it is safe to say my model is a J+,right? Under the J+ series heading on the parts listing there are several columuns, J5 J5H J7 J10, J15. How do know which columun to get my part numbers from? I would like to replace the impeller, but there are four different part numbers listed under those five columns.
Thanks in advance for any help anyone could provide me.
Attachments
Last edited by a moderator: