I am getting ready to install a 3 peice surface mount faucet in my new bathtub. The install requires soldering a "T" fitting between the hot and cold sides to connect to the center spout.
I have never done any soldering. I have read up on the basics but I am wondering about a "T" fitting. Is seems when you solder one joint and then move to the second joint, the heat will loosen the first joint, and so on.
Can anyone give me any tips?
Which torch is the best for a DIY'er?
Thanks!
I have never done any soldering. I have read up on the basics but I am wondering about a "T" fitting. Is seems when you solder one joint and then move to the second joint, the heat will loosen the first joint, and so on.
Can anyone give me any tips?
Which torch is the best for a DIY'er?
Thanks!