pulse power
New Member
- Messages
- 1
- Reaction score
- 0
- Points
- 0
This question may seem a little strange, but I have a situation
where I need to solder a 1" (threaded) bass nipple into a brass plate to
make a very high current joint. How do I get the solder to flow
down all the threads? Flux the two pieces, leave it slightly loose?
Does anybody have any experience doing this?
where I need to solder a 1" (threaded) bass nipple into a brass plate to
make a very high current joint. How do I get the solder to flow
down all the threads? Flux the two pieces, leave it slightly loose?
Does anybody have any experience doing this?