(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 15 of 30

Thread: What did I do wrong?

Hybrid View

  1. #1
    DIY Junior Member alt's Avatar
    Join Date
    Oct 2007
    Location
    Utah
    Posts
    17

    Default What did I do wrong?

    My spouse and I are in the process of fixing up our 1952 ranch home, and we've encountered an electrical problem (that we probably caused

    We replaced the old exterior lights on both the front and back porch with new motion-sensor fixtures. We turned off the power at the correct breaker, and replaced the back porch fixture first. When we turned the power back on, it worked beautifully. So we flipped off the breaker again (they are connected to the same one) we proceeded with the front porch fixture. After it was finished, we once again turned on the breaker, only this time it did not work. Not only that, but ALL the light fixtures that are tied in to this breaker were not working (there are 4... front and back porch, plus hall and stairway light inside).

    We thought perhaps we had wired the front porch fixture incorrectly, so we undid everything, flipped the breaker off and back on again, and still none of the lights will work.

    If you haven't guessed, we are complete novices and don't know much about electrical work. But we did everything according to instructions, so we're a bit flummoxed. Any help you can provide is greatly appreciated.

  2. #2
    Retired Defense Industry Engineer jadnashua's Avatar
    Join Date
    Sep 2004
    Location
    New England
    Posts
    21,405

    Default

    Are the lights on a 3-way circuit (can you turn them on or off from more than one location)? That type of light requires hot, neutral, and ground to be 'fixed' in location (on many of them anyways). When on a 3-way circuit, the hot and neutral can switch if I've got that right. You might get it to work if you flip one switch, then use the other one.
    Jim DeBruycker
    Important note - I'm not a pro
    Retired Defense Industry Engineer; Schluter 2.5-day Workshop Completed 2013, 2014

  3. #3
    DIY Junior Member alt's Avatar
    Join Date
    Oct 2007
    Location
    Utah
    Posts
    17

    Default

    Hi Jim, thanks for the reply.

    No, all of the lights tied to that circuit are operated by a single switch.

  4. #4
    Electrical Contractor/Instructor jwelectric's Avatar
    Join Date
    Jun 2007
    Location
    North Carolina
    Posts
    2,523

    Default

    In the outside light fixture box how many wires of each color are present?

  5. #5
    DIY Junior Member alt's Avatar
    Join Date
    Oct 2007
    Location
    Utah
    Posts
    17

    Default

    One black and one white.

  6. #6
    Computer Programmer Bill Arden's Avatar
    Join Date
    Sep 2006
    Location
    MN, USA
    Posts
    584

    Default

    Some of the motion sensor lights have a "feature" where you can toggle the switch and lock them in a on or off position.

    My lights have a problem where they get stuck and I have to leave the switch off for 10 minutes to reset them.

    Edit: also wait for night since some of these lights have daylight sensors.
    Last edited by Bill Arden; 03-07-2008 at 10:48 AM.
    Important note Ė I donít know man made laws, just laws of physics
    Disclaimer: I'm a big fan of Darwin awards.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •