So here is basic plumbing diagram.
well--->pressure tank---> supply line
The attached picture shows the link coming off the pressure tank. I do not understand why there is a T junction. The pipe to the right goes extends for approximately 6 inches and is capped. It all appears to be 3/4" CPVC, but again I was not aware you could use a compression sleeve to attach to the copper T. I am not sure how long this has been installed for sure, but I know this setup passed my home inspection when I purchased the house almost 4 years ago.
Since the leak has started it appears from the joints of the T my plan is to replace with all CPVC components. The part that I can not decide is whether to just put a 90 elbow on it or replace with a T. Thoughts on the whole setup appreciated.
well--->pressure tank---> supply line
The attached picture shows the link coming off the pressure tank. I do not understand why there is a T junction. The pipe to the right goes extends for approximately 6 inches and is capped. It all appears to be 3/4" CPVC, but again I was not aware you could use a compression sleeve to attach to the copper T. I am not sure how long this has been installed for sure, but I know this setup passed my home inspection when I purchased the house almost 4 years ago.
Since the leak has started it appears from the joints of the T my plan is to replace with all CPVC components. The part that I can not decide is whether to just put a 90 elbow on it or replace with a T. Thoughts on the whole setup appreciated.