ACEBOHRMAN
New Member
I recently installed a 2500 Gallon below ground water tank to catch rain water from the gutter drains on that side of the house to feed 6 zone irrigation system described below.
I will tie into my irrigation system with 1" PVC.
I have 20amps / 115AC available near the tank.
Irrigation system is comprised of 6 zones averaging (3) 5gpm sprinkler heads.
I believe 30 PSI will be sufficient pressure to run 2-3 zones at a time.
The bottom of the water tank is 9'-10' below highest sprinkler head.
The system is currently fed from city meter water through an
above ground anti-siphon valve.
Using this info. can someone recommend a pump type and model to adequately power this system?
How about an inline filter to prevent clogging of the sprinklers and some drip lines although the water should be fairly clean since it goes through a catch basin with 1/8" screen before entering the tank?
Great Forum! Thanks in advance for any recommendations.
I will tie into my irrigation system with 1" PVC.
I have 20amps / 115AC available near the tank.
Irrigation system is comprised of 6 zones averaging (3) 5gpm sprinkler heads.
I believe 30 PSI will be sufficient pressure to run 2-3 zones at a time.
The bottom of the water tank is 9'-10' below highest sprinkler head.
The system is currently fed from city meter water through an
above ground anti-siphon valve.
Using this info. can someone recommend a pump type and model to adequately power this system?
How about an inline filter to prevent clogging of the sprinklers and some drip lines although the water should be fairly clean since it goes through a catch basin with 1/8" screen before entering the tank?
Great Forum! Thanks in advance for any recommendations.