nottick
New Member
- Messages
- 21
- Reaction score
- 0
- Points
- 0
Hello. I have my manifold built, valves installed. Control mounted, etc.
All I have to do now is figure out how to wire the valves to the five wires( I used a five wire jacket - four zones and common, right???)
Any feedback is greatly appreciated.
I beleive figure 8 in this page is what I need. Is there anything else I should know?
http://rainbird.com/pdf/diy/man_CP.pdf
All I have to do now is figure out how to wire the valves to the five wires( I used a five wire jacket - four zones and common, right???)
Any feedback is greatly appreciated.
I beleive figure 8 in this page is what I need. Is there anything else I should know?
http://rainbird.com/pdf/diy/man_CP.pdf
Last edited: