Terry896
New Member
- Messages
- 1
- Reaction score
- 0
- Points
- 0
I was asked to move a waste drain for a new vanity from existing 18" up to 24 1/2" so that i would not cut into a fixed shelf, so I changed the rough.
Now after all the sheetrock / vanity / sink is installed, the water does not drain. It just sits in the basin waiting for something to happen, and eventually does drain.
I am assuming that my waste is now to high. If it is, how can I lower it, without cutting into the fixed shelf? The bottom of the trap is about 2 inches above the shelf at the moment.
Thanks
Now after all the sheetrock / vanity / sink is installed, the water does not drain. It just sits in the basin waiting for something to happen, and eventually does drain.
I am assuming that my waste is now to high. If it is, how can I lower it, without cutting into the fixed shelf? The bottom of the trap is about 2 inches above the shelf at the moment.
Thanks