Folks,
I've done a number of wiring jobs where everything was indoors and I only had to deal with romex.
But running a circuit for a hot tub is throwing me for a bit of a loop. My investigation shows that I can't run romex inside liquid-tite, but I certainly can run that indoors.
How would I best go about running this circuit? Do I get enough 6/3 romex and then strip off the outer insulation to run inside liquid-tite? Or do I setup a waterproof junction box outside where I change from romex to THHN?
Sorry if this seems like a basic question, but installing a subpanel in my garage seemed to be a hell of a lot more straighforward than this project, and there's a ton of conflicting info out on Al Gore's internet.
Thanks in advance for any advice,
Rick
I've done a number of wiring jobs where everything was indoors and I only had to deal with romex.
But running a circuit for a hot tub is throwing me for a bit of a loop. My investigation shows that I can't run romex inside liquid-tite, but I certainly can run that indoors.
How would I best go about running this circuit? Do I get enough 6/3 romex and then strip off the outer insulation to run inside liquid-tite? Or do I setup a waterproof junction box outside where I change from romex to THHN?
Sorry if this seems like a basic question, but installing a subpanel in my garage seemed to be a hell of a lot more straighforward than this project, and there's a ton of conflicting info out on Al Gore's internet.
Thanks in advance for any advice,
Rick