Ross Hunt
Software Engineer
I connected a hose bib to some copper pipe via a female adapter. I was preparing to close the wall when I noticed that the bottom of the threaded joint is just very slightly damp. I have been monitoring it for several days now and there is no drip formation but the slight dampness continues (though - I would say that it is decreasing). I would prefer to not take apart the sweated coupling that is just a few inches away, followed a few inches further by a tee.
Is there a good product to apply to adequately seal that joint or would I be cruising for trouble by not taking it apart and doing it over again.
RH
Is there a good product to apply to adequately seal that joint or would I be cruising for trouble by not taking it apart and doing it over again.
RH