swizzlestick
New Member
- Messages
- 4
- Reaction score
- 0
- Points
- 0
I have a second well on my property that I want to put back in service after many years of sitting idle. My first attempt was cut short by smoking wiring at the well head because the insulation on the pump wire has been damaged where it comes over the edge of the well casing. This was caused, I believe, by there being little to no slack in the pump wires.
I'd like to raise the pump a couple feet to get some slack, cut out the damaged wire and use a splice kit to reconnect. I need to take out a couple feet of black poly pipe to raise the pump. How do I get a secure grip on the pipe while I'm doing this? I don't want to see everything disappear into the well once I cut the pipe.
I'd like to raise the pump a couple feet to get some slack, cut out the damaged wire and use a splice kit to reconnect. I need to take out a couple feet of black poly pipe to raise the pump. How do I get a secure grip on the pipe while I'm doing this? I don't want to see everything disappear into the well once I cut the pipe.