I have an 11 year old Moen tub spout that has a diverter. About 1" from where it attaches to the wall, on the underside of the spout is a rectangular cutout with a hex-screw showing. When I run the tub, I get a few drips out of this hex screw area. When I pull the diverter up there is quite alot of water running what appears to be out of the middle or from around the hex screw. My concern is that with this higher amount, it could get back into the wall and stain my drywall ceiling that sits under the tub. Any ideas if this is normal ? I have not tried adjusting the hex nut yet, was waiting to hear if anyone knew what this did first.
Thanks in advance for any assistance !
Thanks in advance for any assistance !