(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 3 of 3

Thread: Oven/Microwave installed on same wall as service panel

  1. #1
    DIY Junior Member Boo's Avatar
    Join Date
    May 2007
    Location
    California
    Posts
    26

    Default Oven/Microwave installed on same wall as service panel

    Here's new one - sparked (no pun intended!) by a recent recall notice we received from the manufacturer of our new built-in oven (which we haven't even installed yet!).

    We are replacing our old electric range with a new gas cooktop and separate oven/microwave/warming drawer combo. Had plumbers run the new gas lines but since we're moving the appliances to a wall on the opposite side of where they used to be, I'm a bit concerned about our proposed placement of the oven/microwave, etc. The only wall space on the new location will be on the other side of the garage where, unfortunately, the service panel will be pretty much directly on the other side of the oven. Of course, we're using the appropriate fire-rated 5/8" drywall and insulation, but I'm worried that there will be too much heat coming from behind the oven through the cabinet. It's an all-in-one unit that will be put into pre-built cabinets. Nothing in the installation is instructions nor in any of my DIY electrical books addresses this situation.

    This came up because the recall notice said there were reports of fire started when someone used the self-cleaning mode on the oven. I rarely use that feature, but it got me thinking about where we're having to put the oven itself. With the configuration of the new cabinets, this is the only place we can put it.

    As always, thanks for your helpful advice! It's always appreciated and I'm learning something new every time.

  2. #2
    In the Trades brownizs's Avatar
    Join Date
    Feb 2006
    Location
    Springfield, IL
    Posts
    196

    Default

    Personally, I would use Fire-Rated Drywall material, not standard Drywall when dealing with areas that are heat generators.

  3. #3
    Electrical Contractor/Instructor jwelectric's Avatar
    Join Date
    Jun 2007
    Location
    North Carolina
    Posts
    2,523

    Default

    If the cabinets don't catch fire I wouldn't worry about anything else being damaged.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •