Hi I'm in need of help. I replaced the pump and had to do some re-configuring of the plumbing. I used the old squared D swith. I set every thing back up. For the most part it works, thank God.
Here is my problem. The pump senses when its time to fill the tank, but sense when its time to turn the pump off after its full. After reading serveral websites, it seems that I need to measure the PSIs using a gauge. Unfornately the pump that I purchased does not have a gauge for me to determine whether I have enough pressure between the two settings. How do I compensate for this problem?
Robert
Here is my problem. The pump senses when its time to fill the tank, but sense when its time to turn the pump off after its full. After reading serveral websites, it seems that I need to measure the PSIs using a gauge. Unfornately the pump that I purchased does not have a gauge for me to determine whether I have enough pressure between the two settings. How do I compensate for this problem?
Robert
Last edited: